Hot off of the JDM Engineering dyno, here is a tested and proven upgrade kit for 2018-2020 Roush F-150 and Nitemare 650 HP Supercharged pickup trucks! Expect to gain about 50 horsepower and 60 pound feet of torque peak, with generous power gains from idle all the way to Redline! Bringing total output to 700+ HP!! You will roast the tires on demand after our upgrade kit is installed. Increase torque and boost courtesy of a smaller VMP supercharger pulley. JDM Engineering is offering unmatched quality and reliability with safe and efficient improvement in power. Colder spark plugs are also provided to prevent spark blow out and ensure stable cylinder pressure in the toughest of extremes.
Horsepower gains are only half the story with our Roush/Nitemare upgrade kit, as the 10R80 transmission is completely revamped from the ground up in calibration such as shift scheduling, pressures, torque converter lock up, along with shift speed and firmness. Cruising around town is a breeze with silky smooth part throttle shifting. Our shift schedules are so refined that you will struggle to feel the truck downshifting coming to a stop. Gone are clunky multi gear shifts, and indecisive shifts when approaching wide open throttle. Expect a transmission that is eager to downshift and hold each gear a tad longer to ensure never being outside of the power band when desired. When approaching wide open throttle, expect up shifts to be held strictly in sequential order for maximum power at the tire under all conditions.
Below are some videos of a 19' F-150 Roush S/C on our dyno!
Expect your order to be at your door in about 3 weeks from placement!
Please send your completed tune sheet at your earliest convience to: email@example.com so we can commence your order. If you need any help filling out your tune sheet please feel free to email: firstname.lastname@example.org or call 732-780-0770
Important parts and tuning notice:
By ordering this tune, you agree to assume all responsibility for assuring that it is to be used for off-road and/or competition use only and is not to be used on a vehicle that is registered for use on public roads nor highways.
IT IS OUR POLICY TO NOT DISABLE ANY FEDERALLY MANDATED EMISSIONS EQUIPMENT NOR MONITORS ON ANY VEHICLE WITH A VEHICLE IDENTIFICATION NUMBER (VIN). IT IS A FEDERAL OFFENSE FOR US TO DO SO.
Because U.S., Canadian, and other international, state or provincial laws and regulations may prohibit removal or modification of components that were installed on vehicles by Ford Motor Company to meet emission requirements or to comply with motor vehicle safety regulations applicable to vehicles manufactured for use on public roads, JDM Engineering wants you to know the following:
Most of the parts and services offered in this online catalog are for off-road use or competition use only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this off-road or race use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assume all associated risk of the purchase.
Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. JDM Engineering assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of our products or services. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
The emissions laws and regulations of the state of California apply to all non-racing vehicles. Consequently, some parts in this catalog may legally be used in California only on a racing vehicle which will never be operated on public roads.
- 12.00 (in)
- 12.00 (in)
- 6.00 (in)