On Sale! Save 6%

2010-2014 Raptor/F-150 6.2L Roush TVS 2300 Supercharger with JDM 650HP Performance Upgrade

$7,399.00
$6,899.00
(You save )
(2 reviews) Write a Review
Shipping:
Free Shipping

Description

2010-2014 Raptor 6.2L F-150 ROUSH TVS 2300 Supercharger 421245 with JDM 650HP Performance Parts Upgrade Package

Looking for a Supercharger upgrade that will take your 2010- 2014 Raptor SVT F-150 6.2L to the max?  TeamJDM has the set up you've been looking for with the 2010-2014 Raptor 6.2L F-150 ROUSH TVS 2300 Supercharger equipped with our 650HP Performance Parts Upgrade Package. This upgrade kit not only includes the TVS 2300 series twin intercooled Supercharger from ROUSH performance, it also includes all the key components necessary to safely support the power. 650 HP requires a larger supply of fuel to the engine. In order to handle this job TeamJDM has equipped the TVS supercharger with 47lb-hr fuel injectors. The 47lb-hr fuel injectors a are able tyo provide plenty of fuel to the engine while providing great drivability. A 75mm ROUSH supercharger pulley and shorter ROUSH supercharger belt are included to raise boost levels to 9 psi from the factory 7 psi increasing horsepower and torque considerably. A one heat-range colder set of NGK Iridium spark plugs are included in the kit as well to keep heat out of the combustion chamber and help eliminate the risk of detonation. The single most important portion of this kit is a custom SCT tune written by James D'Amore of JDM Engineering using a SCT Xcalibrator 4 flash device.

The base Roush Supercharger package will give you an estimated 590 HP/ 590 TQ which translates to roughly 465 HP at the tires and over 450 TQ. The JDM Engineering 2010-2014 Raptor/F-150 6.2L ROUSH TVS 2300 Supercharger with our 650 HP Performance Upgrade Package will produce over 500 HP at the tires and 480 TQ!  Below is a video of this kit on our dyno!
  

Benefits:

  • Roush TVS 2300 Supercharger supports up to 750 HP
  • Complete with custom tuning specific for your application
  • Instant Torque and throttle response
  • Works with all 6.2L F-150 trucks including Raptor
  • Features Eaton's NEW TVS Twin Vortecies Series technology
Includes:
  • Roush TVS 2300 2.3L Supercharger kit  421245
  • Roush cold air induction system with 100mm MAF
  • Roush Fuel charging assembly
  • Roush intercooler system
  • SCT X4 programmer with custom tune by James D'Amore*
  • Roush 75mm supercharger pulley
  • Roush shorter supercharger belt
  • 47lb-hr fuel injectors*
  • NGK Iridium Spark plugs*

Kit can also be purchased with E-mail Tune only, Choose option before check out.

Add Ford Racing Twin 65mm Throttle Body for an Additional 50 Flywheel Horsepower!

Applications:
  • 2010 Raptor 6.2L SVT F-150
  • 2011 Raptor 6.2L SVT F-150
  • 2012 Raptor 6.2L SVT F-150
  • 2013 Raptor 6.2L SVT F-150
  • 2014 Raptor 6.2L SVT F-150
  • 2011 6.2L F-150 / F-250
  • 2012 6.2L F-150 / F-250
  • 2013 6.2L F-150 / F-250
  • 2014 6.2L F-150 / F-250

*All supercharger kits ship direct from the manufacturer. Normal ship time is 10-15 business days and is subject to change. Call for current availability. 

**Free shipping applies to the lower US 48 sates only. Please contact us directly for HI, AK and international shipping arrangements.  

 

 

CLICK HERE TO DOWNLOAD YOUR TUNE SHEET. 

 

 

 

Please send your completed tune sheet at your earliest convenience to: sales@teamjdm.com  so we can commence your order. If you need any help filling out your tune sheet please feel free to email: sales@teamjdm.com or call 732-780-0770

 

Please allow 10-15 business days for your tuner to be shipped and is subject to change due to high demand and race season.

 

 

 

Important parts and tuning notice:

By ordering this tune, you agree to assume all responsibility for assuring that it is to be used for off-road and/or competition use only and is not to be used on a vehicle that is registered for use on public roads nor highways. 

IT IS OUR POLICY TO NOT DISABLE ANY FEDERALLY MANDATED EMISSIONS EQUIPMENT NOR MONITORS ON ANY VEHICLE WITH A VEHICLE IDENTIFICATION NUMBER (VIN). IT IS A FEDERAL OFFENSE FOR US TO DO SO. 

Because U.S., Canadian, and other international, state or provincial laws and regulations may prohibit removal or modification of components that were installed on vehicles by Ford Motor Company to meet emission requirements or to comply with motor vehicle safety regulations applicable to vehicles manufactured for use on public roads, JDM Engineering wants you to know the following: 

Most of the parts and services offered in this online catalog are for off-road use or competition use only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at 
http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this off-road or race use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assume all associated risk of the purchase. 

 

 

 

Emissions Notice:

 

 

 

Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. JDM Engineering assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of our products or services. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

 

 

 

California Residents

 

 

 

The emissions laws and regulations of the state of California apply to all non-racing vehicles. Consequently, some parts in this catalog may legally be used in California only on a racing vehicle which will never be operated on public roads.

 

 

Additional Details

SKU:
6.2L Roush upgrade
Width:
35.00 (in)
Height:
32.00 (in)
Depth:
24.00 (in)

2 Reviews

  • 5
    2014 Raptor JDM 650hp performance upgrade

    Published by Lou DiGiacomo on 6th Apr 2019

    A review that is long overdue. JDM did my 650hp performance upgrade with Rousch SC, and Ford racing TB, 72mm pulley (13lbs boost), and custom tune. Dyno showed 522rwhp/543TQ before the 72mm pulley, which Jim Jr. said added another 20-25rwhp and 30rwTQ. Know this: Every single time I put my foot on the accelerator I'm ecstatic... and I mean EVERY time! JDM did the upgrades in March 2017, and I'm just as happy now as I was when I picked the truck up from them. I have about $65K just in upgrades on the truck, but the absolute most fun upgrade, and one that is well worth the money, is this one. Jim Sr. is a master of his trade; what Mozart did with music and Schmacher did in F1, Jim Sr. does with tuning and performance. Jim Jr. is extremely knowledgable for his age and was a big help in the development plan. I researched the upgrade for over a year before I made the decision to go with JDM, and I am very, very pleased. If you are considering a performance upgrade for your Raptor, this is money very well spent... and JDM is the very best at doing it.

  • 5
    Sooo Worth It!!!!

    Published by Rob on 15th Jan 2015

    Kit came with good instructions and its a nice clean looking install. Power is awesome and haven't even fully unleashed it yet. Super quiet & tune is right on. Overall great experience thanks to everyone @JDM.

Related Products

Customers Also Viewed

Subscribe to our newsletter

Get the latest updates on new products and upcoming sales

No thanks